root后的启动代码如下,供参考:
root@sabresd_6dq:/ # EXT4-fs (mmcblk0p7): re-mounted. Opts: (null)
ERROR: v4l2 capture: slave not found!
ERROR: v4l2 capture: slave not found!
ERROR: v4l2 capture: slave not found!
ERROR: v4l2 capture: slave not found!
ERROR: v4l2 capture: slave not found!
ERROR: v4l2 capture: slave not found!
ERROR: v4l2 capture: slave not found!
ERROR: v4l2 capture: slave not found!
EXT4-fs (mmcblk0p7): re-mounted. Opts: (null)
warning: `zygote' uses 32-bit capabilities (legacy support in use)
request_suspend_state: wakeup (3->0) at 23445312336 (1970-01-02 00:00:12.815642334 UTC)
cpufreq_interactive_input_connect: connect to max11801_ts
mma enable setting active
eth0: Freescale FEC PHY driver [Generic PHY] (mii_bus:phy_addr=1:01, irq=-1)
ADDRCONF(NETDEV_UP): eth0: link is not ready
acc_open
acc_release
ehci_fsl_bus_resume begins, Host 1
ehci_fsl_bus_resume ends, Host 1
ehci_fsl_bus_resume begins, DR
ehci_fsl_bus_suspend begins, Host 1
ehci_fsl_bus_suspend ends, Host 1
init: sys_prop: permission denied uid:1003name:service.bootanim.exit
request_suspend_state: sleep (0->3) at 92603837345 (1970-01-02 00:01:21.974165343 UTC)
mma enable setting inactive
PM: Syncing filesystems ... done.
PM: Preparing system for mem sleep
suspend: start 1 suspend...
suspend: finish 1 suspend after:0.2603000 seconds...
Freezing user space processes ... (elapsed 0.01 seconds) done.
Freezing remaining freezable tasks ... (elapsed 0.01 seconds) done.
PM: Entering mem sleep
Suspending console(s) (use no_console_suspend to debug)
USB Host suspend begins
ehci_fsl_drv_suspend, pm event
host suspend ends
udc suspend begins
USB Gadget suspend ends
USB Host suspend begins
ehci_fsl_drv_suspend, pm event
host suspend ends
add wake up source irq 101
add wake up source irq 99
add wake up source irq 103
add wake up source irq 51
PM: suspend of devices complete after 12.320 msecs
PM: late suspend of devices complete after 0.604 msecs
Disabling non-boot CPUs ...
CPU1: shutdown
CPU2: shutdown
CPU3: shutdown
Enabling non-boot CPUs ...
CPU1: Booted secondary processor
Calibrating delay loop (skipped) already calibrated this CPU
i.MXC CPU frequency driver
CPU1 is up
CPU2: Booted secondary processor
Calibrating delay loop (skipped) already calibrated this CPU
i.MXC CPU frequency driver
CPU2 is up
CPU3: Booted secondary processor
Calibrating delay loop (skipped) already calibrated this CPU
i.MXC CPU frequency driver
CPU3 is up
PM: early resume of devices complete after 0.424 msecs
wakeup wake lock: alarm_rtc
imx-ipuv3 imx-ipuv3.0: IPU DMFC DP HIGH RESOLUTION: 1(0,1), 5B(2~5), 5F(6,7)
imx-ipuv3 imx-ipuv3.1: IPU DMFC DP HIGH RESOLUTION: 1(0,1), 5B(2~5), 5F(6,7)
remove wake up source irq 51
remove wake up source irq 103
remove wake up source irq 101
remove wake up source irq 99
ehci fsl drv resume begins: DR
ehci_fsl_drv_resume,pm event, wait for wakeup irq if needed
USB Gadget resume begins
fsl_udc_resume, Wait for wakeup thread finishes
ehci_fsl_bus_resume begins, DR
dr_controller_run: udc enter low power mode
USB Gadget resume ends
ehci fsl drv resume begins: Host 1
ehci_fsl_drv_resume,pm event, wait for wakeup irq if needed
ehci_fsl_bus_resume begins, Host 1
ehci_fsl_bus_resume ends, Host 1
PM: resume of devices complete after 97.620 msecs
PM: Finishing wakeup.
Restarting tasks ... done.
suspend: finish 1 suspend after:3.990689324 seconds...
suspend: exit suspend, ret = 0 (1970-01-02 00:01:26.212731333 UTC)
PM: Syncing filesystems ... done.
PM: Preparing system for mem sleep
suspend: start 2 suspend...
suspend: finish 2 suspend after:0.2603333 seconds...
Freezing user space processes ... (elapsed 0.01 seconds) done.
Freezing remaining freezable tasks ... (elapsed 0.01 seconds) done.
PM: Entering mem sleep
Suspending console(s) (use no_console_suspend to debug)
pm_op(): platform_pm_suspend+0x0/0x5c returns -16
PM: Device alarm failed to suspend: error -16
PM: Some devices failed to suspend
PM: resume of devices complete after 0.546 msecs
PM: Finishing wakeup.
Restarting tasks ... done.
suspend: finish 2 suspend after:0.88187332 seconds...
suspend: exit suspend, ret = -16 (1970-01-02 00:01:27.041896666 UTC)
mmc0: Starting deferred resume
mmc0: Deferred resume completed
PM: Syncing filesystems ... done.
PM: Preparing system for mem sleep
suspend: start 3 suspend...
suspend: finish 3 suspend after:0.2659000 seconds...
Freezing user space processes ... (elapsed 0.02 seconds) done.
Freezing remaining freezable tasks ... (elapsed 0.01 seconds) done.
PM: Entering mem sleep
Suspending console(s) (use no_console_suspend to debug)
。。。。。。
如果觉得《imx6 android gadget imx6q安卓启动失败显示Suspending console(s)(已解决)》对你有帮助,请点赞、收藏,并留下你的观点哦!