1、redis.conf文件 需要改动的地方
（1）bind 86.10.113.8 此处为你自己的地址
################################## MODULES ###################################### Load modules at startup. If the server is not able to load modules# it will abort. It is possible to use multiple loadmodule directives.## loadmodule /path/to/my_module.so# loadmodule /path/to/other_module.so################################## NETWORK ###################################### By default, if no "bind" configuration directive is specified, Redis listens# for connections from all the network interfaces available on the server.# It is possible to listen to just one or multiple selected interfaces using# the "bind" configuration directive, followed by one or more IP addresses.## Examples:## bind 192.168.1.100 10.0.0.1# bind 127.0.0.1 ::1## ~~~ WARNING ~~~ If the computer running Redis is directly exposed to the# internet, binding to all the interfaces is dangerous and will expose the# instance to everybody on the internet. So by default we uncomment the# following bind directive, that will force Redis to listen only into# the IPv4 loopback interface address (this means Redis will be able to# accept connections only from clients running into the same computer it# is running).## IF YOU ARE SURE YOU WANT YOUR INSTANCE TO LISTEN TO ALL THE INTERFACES# JUST COMMENT THE FOLLOWING LINE.# ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~bind 86.10.113.8
(2) daemonize no 改为 daemonize yes 以后台静默进程启动
################################# GENERAL ###################################### By default Redis does not run as a daemon. Use 'yes' if you need it.# Note that Redis will write a pid file in /var/run/redis.pid when daemonized.daemonize yes
(3)protected-mode yes 把yes改为no
# Protected mode is a layer of security protection, in order to avoid that# Redis instances left open on the internet are accessed and exploited.## When protected mode is on and if:## 1) The server is not binding explicitly to a set of addresses using the# "bind" directive.# 2) No password is configured.## The server only accepts connections from clients connecting from the# IPv4 and IPv6 loopback addresses 127.0.0.1 and ::1, and from Unix domain# sockets.## By default protected mode is enabled. You should disable it only if# you are sure you want clients from other hosts to connect to Redis# even if no authentication is configured, nor a specific set of interfaces# are explicitly listed using the "bind" directive.protected-mode yes
2、启动服务
方式一、
重启redis服务
systemctl restart redis.service
设置redis服务为开机自启
systemctl enable redis.service
查看redis是否启动成功
ps aux | grep redis
systemctl status redis
方式二、
启动服务
/usr/local/bin/redis-server /etc/redis/redis.conf
查看redis是否启动成功
ps -ef|grep redis
如果觉得《Linux环境 redis完整配置及启动命令》对你有帮助，请点赞、收藏，并留下你的观点哦！
